Speed Converter

Convert speed to and from centimeters/minute, centimeters/second, feet/hour, feet/minute, feet/second, inches/minute, inches/second, kilometers/hour, kilometers/second, knots, Mach number (ISA/Sea level), meters/hour, meters/minute, meters/second [m/s], miles/hour, miles/minute, miles/second, nautical miles/hour, Nm/24hr (Volvo Ocean Race), speed of light, yards/hour, yards/minute, yards/second etc.

From: centimeters/minute


To: centimeters/minute


How to use this Speed Converter Tool?

How to use Yttags's Speed Converter?

  • Step 1: Select the Tool
Speed Converter Step 1
  • Step 2: To perform a Speed Converter, walk through the steps below:
  1. Select the unit of the From(source).
  2. Enter the From(source) value into the box at the top left.
  3. Select the unit of the To(target).
  4. The Speed Converter is automatically performed and the result is displayed at the right-hand side.
Speed Converter Step 2

Units of measurement

Conversion units for the Speed Converter

centimeters/minute, centimeters/second, feet/hour, feet/minute, feet/second, inches/minute, inches/second, kilometers/hour, kilometers/second, knots, Mach number (ISA/Sea level), meters/hour, meters/minute, meters/second [m/s], miles/hour, miles/minute, miles/second, nautical miles/hour, Nm/24hr (Volvo Ocean Race), speed of light, yards/hour, yards/minute, yards/second


If you want to link to Speed Converter page, please use the codes provided below!

Speed Converter

FAQs for Speed Converter

What is speed?
Speed is the rate at which an object moves or the distance covered by an object in a given amount of time, typically measured in units like meters per second (m/s) or kilometers per hour (km/h).
How to convert between units of speed? - speed conversion
To convert between units of speed, use conversion factors: 1 m/s = 3.6 km/h, 1 m/s = 2.237 mph, and then apply simple multiplication or division depending on the desired conversion.
What units of speed are supported?
Units of speed supported include meters per second (m/s), kilometers per hour (km/h), miles per hour (mph), feet per second (ft/s), and knots (nautical miles per hour).
How do you calculate speed and feed?
Speed and feed are typically calculated in machining processes. Speed is the rate at which the cutting tool moves relative to the workpiece, while feed is the distance the tool advances in one revolution or linear motion. They are calculated based on the material being machined, cutting tool, and desired surface finish and are usually specified in units like meters per minute (m/min) or inches per revolution (IPR).
What RPM should you mill steel?
The recommended RPM (Revolutions Per Minute) for milling steel depends on various factors such as the diameter of the cutting tool, the hardness of the steel, and the specific machining operation. It is best to consult the manufacturer's recommendations or machining guidelines for the cutting tool being used to determine the appropriate RPM for milling steel.